
Staff Product Engineer- Sustaining
- Philippines
- Permanent
- Full-time
- Provide support on company goals through generation of cost reduction activities and efficiency projects.
- Initiate yield improvement activities on DS and FT testing and provide technical support on assembly yield enhancement.
- Provide product and technical support on Sub-Con and Fab transfers through reliability and qualification activities.
- Provide disposition on all hold lots detected through yield loss within a specified lead time and drive improvement to reduce lots being held.
- Provide support on the closure of NOVs and MRBs issued to address product and line abnormalities and disturbances detected.
- Monitor and report DS and FT yield including rooms for continuous improvement.
- Provide technical and product support and recommendation during bench testing and electrical verification of customer requirements and CAR units.
- Provide technical and product support on 8D generation and closure.
- Provide support and perform activities required on various PCNs.
- Prepare monitor and ensure timely completion of the reliability requirements of the product improvement under qualification through the 1910 and 1930 documents.
- Perform performance and parametric analysis of the test result of the device and advise findings and recommendations for product.
- Update the test plan and define the limits needed in ensuring that the product adheres to Vishay Quality standards during product testing, if necessary
- Update the manufacturing product flow setup upon product improvement release.
- Prepare and update the datasheet, if needed
- Ensure results are communicated to all stakeholder, including but not limited to, the success rate of the product improvement qualification made.
- Supervise safe launch plan to monitor and track product performance and improvement effectiveness over a defined criteria.
- Monitor and reports MRT and ORT
- Update the SYL and SBL setup of running models based on its recent performance.
- Graduate of BS Electronics Engineering or BS Electrical Engineering
- At least 5 years of experience in Product and/or Test Engineering, preferably in a semiconductor environment
- Knowledgeable in Discrete, MOSFETS, IPD, Analog Switch devices
- Proficient in computer processes
- Has good oral and written communication skills